Creating Energy: How To Build Solar Panels In Your Own Home

It is time that we realize the need to use environmentally generated energy than fuel generated energy. This we can do in our own little way at home to cut down on power bills, hence valuable money as well as do something to save the planet. The nice thing of getting this done is that it is a learning experience for a person and also for an entire family too. Start creating your solar powered battery to yoke the power of the sun, a trip to the hardware shop is required. Learn how to build solar panels.

The good thing about doing this is it can be a fun exercise for an individual and of course, for the entire family as well. To get started on making your cell to harness the energy from the sun to power your home, you will need to make a visit to the hardware store.

One does not need more than half square foot copper flashing sheet, an electrical food heater, one container with a large opening, one efficient micro-ammeter, salt, water, sand paper, shears to cut metal and finally two clip leads.

First thing, wash hands to keep clean and dry. Cut a piece of the copper sheeting to the size of the diameter of the electric stove. Now, wash copper sheet with soap to rid it of any oil. With sand paper, clean the sheet really well.

Once this is complete, let the sheet cool off without inducing the cooling process. It will be seen that the sheet is getting smaller. Flaking of the chemical deposits will be seen at this point.

Upon completion of this process, the sheet has to be cooled off at room temperature. You will notice that it is reducing in size as it gets to a normal temperature. It is during this process one see the accumulation of the dry bits of chemicals on the sheet.

You will now need another sheet of copper around the same dimensions as the first. Fit them into the bottle without letting them touch each other. The side of the sheet facing up on the stove should face out into the bottle.

Now, attach your clip leads, one to the new copper plate, and one to the COOKED one. The clean sheet should be attached to the positive side of the meter and the cooked one to the negative.

Now, attach the leads. The second sheet should be wired to the positive area of the meter and the first one must be clipped to the negative one. In hot water, put in a good number of tablespoons of salt and mix thoroughly. This concoction has to be poured into the bottle ensuring that the sheets are not submerged up to an inch from top. This is your home manufactured solar panel!

To think it would light up bulbs and other electrical appliances would be foolish. This power box can produce only 50 micro amps at 0.25 volts. One will need hundreds of these to power an entire home which would be a major expenditure.

-->